This is the planned tasks for the RGA and reflector EVA.
EV1 exits the airlock first wearing red stripes
and EV2 exits second wearing white stripes.
The first task in this EVA is to remove and replace
RGA 2 in the S-0 truss location.
EV1 will be working on the backside of the truss.
They will carry the new RGA to the work site,
Remove the bolts and connectors, and then pull the old RGA out,
Ev2 will be positioned inside the truss to assist
with removing the electrical connections, and the bolts.
They will then put the new RGA in place.
Once the RGA R&R is complete, EV2 will move to the node two zenith
docking port to remove and replace the planar reflector.
EV2 will remove three bolts in order to remove the planar reflector.
They will then put the new
one into its place and bolt it back down.
Before leaving the worksite, EV2 will take photos of the new reflector and its surrounding area.
Meanwhile, EV1 will be working on the NICER payload
located on the S-3 outboard truss.
EV1 will be installing wedge shaped patches from the caddy
to cover the damaged areas of the light detectors.
Once complete, they will then take photos
to confirm the configuration is correct.
EV1 will then move to the AMS worksite
to move a C2V2 cable to allow access to the payload.
Once both crew members meet up at the AMS worksite,
EV1 will ingress the truss to access the AMS patch panel
and then remove the cloth covering.
EV1 will then do fit checks to determine
what connectors are easily accessible for future upgrades.
Once complete with their tasks, both crew members will then go
back to the airlock and ingress, marking the end of the RGA and Reflector EVA.